RUDDER PINTLE AND BUSH MATERIALS

Trade Agreement: NAFTA/AIT/Canada-Peru FTA/Canada-Colombia FTA Tendering Procedures: Attachment: None Competitive Procurement Strategy: Lowest/Lower Bid Comprehensive Land Claim Agreement: No Nature of Requirements: RUDDER PINTLE AND BUSH MATERIALS

F2599-120346/A Tamaro, Daniel Telephone No. - (819) 956-5319 ( ) Fax No. - (819) 956-0897

RUDDER PINTLE AND BUSHING MATERIAL FOR CCGS GRIFFON

The Canadian Coast Guard intends to renew the rudder pintles, of the CCGS Griffon at a later date. The Contractor will provide rough material stock for three rudder pintles, three rudder pintles nuts, and three rudder pintel bronze bushings. All material inspected, approved and stamped with identification marks by a Marine Classification Society, approved by Transport Canada Marine Safety.

Rough material stock required

a. Marine Classification Society material approved and stamped for rudder pintle and nuts as follows: forged 410 Stainless Steel material normalized and tempered for the rudder pintles and nuts.

· One piece of round stock 43 inches long by 12 inches in diameter; · One piece of round stock 81 inches long by 8.5 inches in diameter.

b. Marine Classification Society material approved and stamped material for rudder pintel bronze bushings rough cut material Bronze C93200 / SAE 660 continuous cast for the three bushings for pintles. The rough cut size is the same for the upper, middle and lower bushings:

· One piece 34 inches long by 13.5 inches O/D with 7 inches I/D.

The requirement is subject to the Agreement on Internal Trade (AIT) and the North American Free Trade Agreement (NAFTA).

Firm Delivery Date: On or before March 29, 2013 Delivery Date: Above-mentioned

The Crown retains the right to negotiate with suppliers on any procurement.

Documents may be submitted in either official language of Canada.